Epson Stylus Pro GS6000 - Chapter 6 Maintenance

Epson Stylus Pro GS6000 Revision F
MAINTENANCE Maintenance 244
Confidential
6.3 Maintenance
When servicing, check the status of the following parts, and carry out cleaning, or
replacement as necessary.
CLEANER HEAD
Make sure there is no stuck dry ink on it. If stuck ink is observed, clean the Cleaner
Head using the Cleaning Stick and the Ink Cleaner. If it does not improve the status
much, replace it with a new one. Check also the status of the ink gully. If too much ink
is piling in the gully and may cause ink to overflow at the next cleaning, replace the
Assy with a new one.
 Cleaning → p247
 Replacement → p166
Figure 6-4. Around the CLEANER HEAD
PRINT HEAD
Make sure there is no dust, dirt, or stuck dry ink around the PRINT HEADs. If such
abnormality is observed, carry out cleaning using the Cleaning Stick and the Ink
Cleaner. (This cleaning is basically expected to be carried out by the users. If the
cleaning turns out to be insufficient when checking, explain to the user the importance
of performing proper regular cleaning.) If the cleaning does not improve the status
much, replace the part with a new one.
 Cleaning → p249
 Replacement → p158
Figure 6-5. Around the PRINT HEAD
Check
Point
As seen from the front
CLEANER HEAD
C H E C K
P O I N T
You may use the metallic tray (provided with the printer) as a
mirror for more convenience.
As seen from the front left
Check
Point
PRINT HEADs