Epson Stylus Pro GS6000 - Page 245

Epson Stylus Pro GS6000 Revision F
MAINTENANCE Maintenance 245
Confidential
VALVE ASSEMBLY
Check the inside and make sure no stuck dry ink blocks the ink flow paths (holes). If
such abnormality is seen, replace the assembly.
 Replacement → p158
Figure 6-6. Around the VALVE ASSEMBLY
CAP HEAD
Check the surface of the CAP HEAD. If it is not wet with ink, replace it with a new
one. (If the pad is dry, it may be due to air infiltration caused by a cap shape
deformation or deterioration.)
 Replacement → p162
Figure 6-7. CAP HEADs
FLUSHING BOX ASSY
Remove the Flushing Box Unit and confirm the Ink path (hole) is OK. If stuck dry ink
blocks the path, carry out cleaning or replacement.
 Replacement → p165
Figure 6-8. Under the Flushing Box Unit
Check
Point
As seen from the top
Ink flow paths
Ink flow paths
Check
Point
As seen from the front
CAP HEADs
Check
Point
As seen from the top
Ink path