Epson Stylus Pro GS6000 - Other Adjustments; RTC and USB ID

Epson Stylus Pro GS6000 Revision F
ADJUSTMENT Other Adjustments 224
Confidential
5.6 Other Adjustments
5.6.1 RTC and USB ID
This allows you to reset the date and time of the RTC backup battery and to set the
USB ID.
 Procedure
1. Turn the printer ON.
2. Start the Service Program and select RTC and USB ID.
 Writing RTC data
3. Check if the date and time displayed on the screen is correct.
Enter the correct date and time if necessary.
4. Click the [Write RTC] if you wish to modify the registered date and time.
 Writing USB ID
5. Input the 10-digit serial number of the printer. USB ID is automatically
created according to the serial number.
6. Click the [Write USB ID] to write the USB ID on the NVRAM of the new
Main Board.
 Confirmation
7. Click the [Next] button to display a confirmation screen. The information
written on the NVRAM is displayed on the screen. Confirm the information
and click [OK].
8. Click the [Finish] button.
Figure 5-39. [RTC and USB ID] Screen
C H E C K
P O I N T
Writing RTC data and Writing USB ID can be performed
individually.
C A U T I O N
If the printer is turned OFF and back ON after changing the USB
ID, the computer (Windows) detects the USB port used to connect
the printer as a new port and automatically copies the printer
driver as xxxx (copy x). If you need to perform another adjustment
using the Service Program, exit out of the program once and select
the “copy x” driver next time.