Epson Stylus Pro GS6000 - IP Address Setup & Network Test

Epson Stylus Pro GS6000 Revision F
ADJUSTMENT Other Adjustments 228
Confidential
5.6.4 IP Address Setup & Network Test
5.6.4.1 IP Address Setup
The IP Setup is not included in the NVRAM so it is necessary to write it when a new
board is installed. Set the IP address by the panel in the User's menu. See the User's
Guide for further explanations about the IP address setup.
5.6.4.2 Network Test
Use this to check if the printer can communicate with the computer via a network.
 Procedure
1. Turn the printer ON.
2. Start the Adjustment Program, and select “Network Communication
Confirmation”.
3. Turn the printer ON.
4. Start the Service Program and select Check Network Communication menu.
5. Enter the IP address of the printer, and press [Run].
When the network communication is available, a status sheet is printed
automatically.
6. Click the [Finish] button.
Figure 5-44. [Check Network Communication] Screen