Epson Stylus Pro GS6000 - Around the Print Head

Epson Stylus Pro GS6000 Revision F
MAINTENANCE Cleaning 249
Confidential
6.4.2 Around the Print head
1. Perform Step 1 to Step 5 in “Cleaning Wiper (p247)”.
2. Open the MAINTENANCE COVER ASSY (left).
Figure 6-13. Opening the Maintenance cover (left)
3. Using a penlight or the like, confirm that there are no foreign objects, such as dust
or ink attached on or around the PRINT HEADs as shown in the figure below.
Figure 6-14. Checking around the PRINT HEAD
4. If foreign objects, such as dust or ink are attached to the PRINT HEAD, remove
them using the Cleaning Stick.
5. If the dirt does not come off, use the Ink Cleaner. See "6.4.1 Cleaning Wiper" Step
8. (p247).
Figure 6-15. Cleaning around the PRINT HEADs
(1)
(2)
MAINTENANCE COVER ASSY (left)
Check
Point
PRINT HEADs
C A U T I O N
 Do not touch the nozzle of the PRINT HEAD, or the PRINT
HEAD may be damaged.
 Do not touch the head of the Cleaning Stick with bare fingers,
or oil on your hand may be attached to the Cleaning Stick. It
may cause damage to the PRINT HEAD.
 Never dip the head of the Cleaning Stick in water. Otherwise,
the water on it will react with the solvent and damage the
PRINT HEAD.
 Do not reuse the Cleaning Sticks without rinsing. Dust attached
to the stick may damage the PRINT HEAD.
PRINT HEADs