Diagram Name Description
1 PG HP Sensor Detects the home position of the platen gap.
2 Paper Edge Sensor Detects the right and left ends of paper.
3 Paper Rear Sensor Detects the presence of paper.
4 CR HP Sensor
Detects the home position of the Carriage Unit (CR
Cursor Assy.).
5 M Cover Sensors
Detect the opening/closing status of the Maintenance
Covers.
6 Lever Sensor Detects the position of the paper lever.
7
Waste Fluid Level
Switch Assy
Detects the amount of waste ink. If the waste ink
exceeds specified level, the sensor reacts.
8 Sub Tank Sensors
Detect the remaining ink in the Sub Tanks. Each tank
has two sensors, and the remaining ink is detected in
stages.
9 IC Cover Sensors Detect the opening/closing status of the Ink Covers.
10 F Cover Sensors Detect the opening/closing status of the Front Cover.
To Next Page
Loading...
