Epson Stylus Pro GS6000 - Media Side Margin Adjustment

Epson Stylus Pro GS6000 Revision F
ADJUSTMENT CR Related Adjustments 206
Confidential
5.3.4 Media Side Margin Adjustment
This allows you to adjust the margin provided before starting printing.
 Required Tool
Ruler
 Paper Used
 Size: 1250 mm
 Type: Marking Film
 Standard Value
5 mm
 Procedure
1. Refer to ?5.1.6 Cautions and Preparation for Pattern Printing? (p.197), and
prepare for printing the pattern.
2. Select Adjustment => Feed Adj. +Side => [Enter] Print, and press the
[Enter] button to print an adjustment pattern.
3. Measure the margin at A and B points shown in the figure.
4. Enter the average value of the two measured values, and press the [Enter]
button.
5. Print the adjustment pattern again, and check that the margin length is 5 mm
(specified value).
Figure 5-23. Adjustment Pattern
C A U T I O N
Be sure to place the adjustment pattern print on a flat surface when
performing the measurement.
C H E C K
P O I N T
If there is a big difference between the two values, the paper is
skewed. Re-set the paper correctly.
A
B
TOP MecNo. XXXXXXXXXX Date&Time (YY - MM - DD HH : MM : SS) xx - xx - xx xx : xx : xx