Epson Stylus Pro GS6000 - Page 205

Epson Stylus Pro GS6000 Revision F
ADJUSTMENT CR Related Adjustments 205
Confidential
9. When the carriage unit contacts with the lower section or goes over the higher
section without contact, the carriage unit height must be adjusted. Follow the
procedure below to make the adjustment.
10. Loosen the adjustment screw that secures the Head UD Collar on the left and
right sides of the carriage unit.
11. Move the Head UD Collars up or down to adjust the height of the carriage
unit.
12. Tighten the two screws to secure the Head UD Collars.
13. Restart from Step 5 to check the adjustment result.
Figure 5-22. Adjusting the Height of Carriage Unit
UD Collar UD Collar