Epson Stylus Pro GS6000 Revision F
TROUBLE SHOOTING Remedies for Error Messages 51
Confidential
3.2 Remedies for Error Messages
The Error messages and their corresponding remedies are explained below.
Message on LCD Description Remedy/Point to be checked
INK LOW The ink cartridge is nearly expended. The ink cartridge is nearly empty. Although you can continue printing in
the INK LOW status, it may decrease the print quality.
DRAIN TANK FULL
DRAIN WASTE INK FROM THE
DRAIN TANK
The ink drain tank is full. Drain waste ink from the ink drain tank immediately.
Malfunction of the WASTE FLUID LEVEL SW ASSY. Check whether the WASTE FLUID LEVEL SW ASSY operates
normally or not (p.234). If any abnormality is found, check the cable
connection status, and replace the WASTE FLUID LEVEL SW ASSY if
necessary.
INK CARTRIDGE INSTALL
INK CARTRIDGE
This message appears when replacing the ink cartridge. Install an ink cartridge.
LEVER RELEASED
LOWER THE PAPER SET LEVER
The paper lever (PRESSURE LEVER) is in the released position. Move the paper lever (PRESSURE LEVER) to its lowest position to
secure paper.
LEVER RELEASED
LOAD PAPER
If this message appears although the lever is lowered, there is something
wrong with the LEVER SENSOR.
Check whether the LEVER SENSOR operates normally or not (p.234). If
any abnormality is found, check the cable connection status, and replace
the LEVER SENSOR (p.133) if necessary.
FRONT COVER OPEN
CLOSE FRONT COVER
The FRONT CLEAR COVER is open. Close the FRONT CLEAR COVER.
The F COVER SENSOR is not installed correctly, or there is something
wrong with the sensor.
Check whether the FRONT CLEAR COVER properly pushes the sensor.
If not, adjust the sensor position.
When the sensor does not operate, check the cable connection status and
replace the F COVER SENSOR (p.133) if necessary.
MAINT COVER OPEN
CLOSE RIGHT MAINT COVER
The MAINTENANCE COVER ASSY(s) is open. Close the MAINTENANCE COVER ASSY(s).
MAINT COVER OPEN
CLOSE LEFT MAINT COVER
If this message appears although the cover is closed, there is something
wrong with the M COVER SENSOR.
Check whether the M COVER SENSOR operates normally or not
(p.234). If any abnormality is found, check the cable connection status,
and replace the M COVER SENSOR (p.133) if necessary.
INK COVER OPEN CLOSE RIGHT AND
LEFT INK COVERS
The Ink Cover(s) is open. Close the Ink Cover(s).
INK COVER OPEN
CLOSE RIGHT INK COVER
If this message appears although the cover is closed, there is something
wrong with the IC COVER SENSOR.
Check whether the IC COVER SENSOR operates normally or not
(p.234). If any abnormality is found, check the cable connection status,
and replace the IC COVER SENSOR (p.133) if necessary.
INK COVER OPEN
CLOSE LEFT INK COVER
NOT ENOUGH INK REPLACE INK
CARTRIDGE WITH A NEW ONE
The ink cartridge is nearly expended. Replace the ink cartridge with a new one.
To Next Page
Loading...
