Epson Stylus Pro GS6000 - PF Related Adjustments; PF Reduction Belt Tension Adjustment

Epson Stylus Pro GS6000 Revision F
ADJUSTMENT PF Related Adjustments 222
Confidential
5.5 PF Related Adjustments
5.5.1 PF Reduction Belt Tension Adjustment
When the PF REDUCTION BELT tension is loosened, this adjustment must be carried
out to apply proper tension to the PF REDUCTION BELT.
 Required Tool
Push-pull gauge (the one which can measure 3.85 kg)
 Standard value
3.5kg ± 10%
 Parts need to be removed in advance
 TOP COVER L
 MAINT COVER T
 SIDE COVER, L
 IH COVER L
 Procedure
1. Loosen the two screws that secure the PF MOTOR.
2. Attach the gauge to the shaft of the PF MOTOR, and pull the gauge toward
the rear of the printer.
3. With the specified value is indicated on the scale of the gauge, tighten the two
screws to secure the PF MOTOR.
Figure 5-37. PF Reduction Belt Tension Adjustment
The view as seen from the top
Push-pull gauge
Screws