Epson Stylus Pro GS6000 Revision F
ADJUSTMENT Tests 236
Confidential
5.8.3 Electric Components Test
This test menu allows you to confirm whether or not the electric components such as sensors and fans operate normally.
Basic Operation
1. Enter the Serviceman Mode.
Turn the printer ON while pressing [Pause/Reset] + [Paper Feed ] + [Menu] simultaneously.
2. When SELF TESTING is displayed, press the [Enter] button to enter the self-diagnostic menu.
3. Referring to the table below, perform the test corresponding to the part you wish to test.
Check list by repaired part
Test Menu Related Parts Procedure Check/Action
Sensor Test FRONT CLEAR COVER
1. Select the menu as follows.
Ctrl. Test => Ctrl. Sns => CtrlSns. Etc => Front Cover
2. Open and close the FRONT CLEAR COVER.
Check that the sensor status changes according to the opening/
closing operations.
Sensor Status: Open/Close, Main Board Status: OK/NG
The left and right cover sensors are designed so that they do not react
when the other one is in open status. Make sure to check the left and
right cover sensors individually.
F COVER SENSOR R
F COVER SENSOR L
CR HP SENSOR
1. Select the menu as follows.
Sensor => CR Origin
2. Manually move the CR CURSOR ASSY to the home position or
away from the home position.
Check that the sensor status correctly reflects the CR CURSOR
ASSY position (Home position = “On”).
Status: On/Off
LEVER SENSOR
1. Select the menu as follows.
Sensor => PG
2. Move the Head Height Adjustment Lever between its highest and
lowest positions.
Check that the sensor status correctly reflects the lever position.
Status: Low/High
PG HEIGHT SENSOR
M COVER SENSOR R
1. Select the menu as follows.
Ctrl. Test => Ctrl. Sns => CtrlSns. Etc => Mainte Cover
2. Open and close the right Maintenance cover.
Check that the sensor status changes according to the opening/
closing operations.
Sensor Status: Open/Close, Main Board Status: OK/NG
M COVER SENSOR L
1. Select the menu as follows.
Ctrl. Test => Ctrl. Sns => CtrlSns. Etc => Mainte Cover
2. Open and close the left Maintenance cover.
Check that the sensor status changes according to the opening/
closing operations.
Sensor Status: Open/Close, Main Board Status: OK/NG
IC COVER SENSOR R
1. Select the menu as follows.
Ctrl. Test => Ctrl. Sns => CtrlSns. Etc => Ink Cover
2. Open and close the right Ink cartridge cover.
Check that the sensor status changes according to the opening/
closing operations.
Status: Open/Close
To Next Page
Loading...
