Epson Stylus Pro GS6000 - Carriage Mechanism

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 142
Confidential
4.4.9 Carriage Mechanism
4.4.9.1 CR BELT
1. Remove the TOP COVER (L & R). (p85)
2. Remove the PANEL COVER, T (p86) and MAINTE COVER T. (p88)
3. Remove the SIDE COVER (L & R). (p89)
4. Unlock the Carriage and move it to the center. (p83)
5. Loosen the two adjustment screws of the Driven Pulley to relieve the tension of
the CR BELT.
Figure 4-108. Relieving the tension of the CR BELT
6. Remove the two screws beside the Carriage.
A) Silver, Phillips, Pan with S.W & P.W M3x40: two pieces
7. Draw out the CR BELT through the hole behind to remove it.
Figure 4-109. Removing the CR BELT
Driven Pulley
Adjustment Screw
CR BELT
As seen from the left
A
CR BELT
As seen from the front
Carriage