Epson Stylus Pro GS6000 - Page 143

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 143
Confidential
 When reassembling the CR BELT, make sure to replace the
screws with new ones. These screws can be used only once. See
Figure 4-109.
 After installing the belt and carrying out the specified
adjustment, make sure to secure the adjustment screws and
shaft of the Driven Pulley with thread-locker (x6) as shown
below.
 Make sure you do not drop thread-locker on the CR Belt or on
the pulley as it would prevent it from running smoothly.
Driven Pulley
CR BELT
Thread-lock points (bottom)
Both sides of the shaft
Thread-lock points (top)
Both sides of the shaft
Thread-lock
points
Screw holes
As seen from the left
 When putting the CR BELT through the hole, follow the steps
below.
1. Put some tape around the hole edges (both sides) to prevent
damaging the CR BELT.
2. Pass a tape measure through the hole.
3. Attach the CR BELT to the tip of the tape measure with tape.
4. Draw the scale from the hole carefully to pass the belt through
the hole.
A D J U S T M E N T
R E Q U I R E D
Be sure to refer to Chapter 5 “Adjustment” (see p184) and perform
specified adjustments after replacing or removing the CR Belt.
<Adjustment items>
1. CR Belt Tension Adjustment
2. Media Side Margin Adjustment
Tape measure
Hole
As seen from the left
Tape measure
Tape
CR BELT
As seen from the right