Epson Stylus Pro GS6000 - Fans

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 101
Confidential
4.4.5 Fans
4.4.5.1 COOLING FAN (24V)
1. Remove the TOP COVER (both). (p85)
2. Remove the REAR COVER. (p95)
3. Remove the FRONT CLEAR COVER. (p94)
4. Remove the ten screws from the Mid Top Cover (not an ASP).
A) Silver, Phillips, Pan with S.W & P.W M3x8: ten pieces
5. Avoiding the hinges, remove the cover.
Figure 4-44. Removing the Mid Top Cover
6. Disconnect the relay connector and release the cable.
7. Remove the two screws and remove the COOLING FAN (24V).
A) Silver, Phillips, Pan with S.W & P.W M3x30: two pieces
Figure 4-45. Removing the COOLING FAN (24V)
C A U T I O N
In the next step, take care not apply excessive force to the hinges on
both sides of the Front Clear Cover. It may cause misalignment of
the hinges’ phase.
A
As seen from the front
As seen from the rear
Mid Top Cover
Mid Top Cover
When routing the cable, make sure to give it one turn around the
cable clamp as shown in figure below.
A
Inside the Mid Top Cover
Clamp to turn
COOLING
FAN (24V)
Relay
connector
As seen from the left