Epson Stylus Pro GS6000 - Paper Feed Adjustment

Epson Stylus Pro GS6000 Revision F
ADJUSTMENT PF Related Adjustments 223
Confidential
5.5.2 Paper Feed Adjustment
This is to adjust the paper feeding amount.
 Required Tool
Ruler (that can measure 1,000 mm)
 Paper Used
 Size: 1250 mm
 Type: Marking Film
 Standard Value
980 mm ± 10 mm
 Procedure
1. Refer to ?5.1.6 Cautions and Preparation for Pattern Printing? (p.197), and
prepare for printing the pattern.
2. Select Adjustment => Feed Adj. +Side => [Enter] Print, and press the
[Enter] button to print an adjustment pattern.
3. Measure the length indicated on the figure.
4. Enter the measured value and press the [Enter] button.
5. Print the adjustment pattern again and check that the length is the specified
value.
Figure 5-38. Adjustment Pattern
C A U T I O N
Be sure to place the adjustment pattern print on a flat surface when
performing the measurement.
C H E C K
P O I N T
Using the PAPER FEED ADJUST in the user mode, the paper feed
adjustment can be carried out using the paper used by the user for
each user defined paper setup.
TOP MecNo. XXXXXXXXXX Date&Time (YY - MM - DD HH : MM : SS) xx - xx - xx xx : xx : xx