Epson Stylus Pro GS6000 Revision F
ADJUSTMENT NV-RAM BACKUP UTILITY 198
Confidential
5.2 NV-RAM BACKUP UTILITY
Whenever the Main Board is replaced, parameters stored in the NVRAM on the
previous board should be backed up and written onto the new board using this menu.
Backup Procedure
1. Turn the printer ON.
2. Start the Service Program and select NV-RAM BACKUP UTILITY.
3. Click the [Get Information] button to start reading the parameters.
4. When the reading is completed, input the Printer Serial Number in the
appropriate filed and click the [Save] button to save the readout parameters
under the name you have just input in the Serial Number field.
5. In some areas, tables showing NVRAM information will be displayed after
clicking [Save]. (NVRAM Viewer) Click [Close] to exit the viewer.
6. Turn the printer OFF.
Restore Procedure
1. Enter the Firmware Update Mode.
Turn the printer ON while pressing [Paper Feed ] + [Paper Feed ] +
[Heater ] + [Menu ] simultaneously.
2. Start the Service Program and select NV-RAM BACKUP UTILITY.
3. Click the [Open] button to select and open the file which was saved in
“Backup Procedure”.
4. Click the [Write] button to start writing the parameters.
5. When the writing is completed, exit out of the NVRAM Backup Utility.
Figure 5-11. NV-RAM BACKUP UTILITY Screen
When the printer does not become ready status due to some
error, turn the printer on in the serviceman mode and carry
out the backup.
The program detects the printer automatically. Do not connect
more than one printer at the same time or an error message
will appear at the printer communication timing.
To Next Page
Loading...
