Epson Stylus Pro GS6000 - Take-Up Reel Unit

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 177
Confidential
4.4.12 Take-Up Reel Unit
REMOVING THE TAKE-UP UNIT COVER (COMMON PROCEDURE)
1. Remove the Spindle.
2. Remove the screw on the left end and the two screws on the right end and remove
the Roller Shaft.
A) Silver, Hexagon socket M4x10: three pieces
Figure 4-157. Removing the Spindle and the Roller Shaft
3. Remove the seven screws from the box on the right.
A) Black, Phillips, Bind machine screw M3x4: seven pieces
4. Remove the lever by unscrewing it with a flat nose pinch.
5. Loosen the screw and remove the dial on the right.
B) Black, Hexagon socket M1.5x4: one piece
6. Remove the Take-Up Unit Cover.
Figure 4-158. Removing the Take-Up Unit Cover
As seen from the rear
Spindle
Roller Shaft
A
Two screws
Dial
B
A
As seen from the right
Lever
Take-Up Unit
Cover