Epson Stylus Pro GS6000 - Heaters;Thermistors

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 137
Confidential
4.4.8 Heaters/Thermistors
4.4.8.1 PRE HEATER (64)/THERMISTOR, PRE
1. Remove the REAR PAPER GUIDE.(p96)
2. Peel off the heat insulator.
3. Peel off the PRE HEATER(64)s and remove them.
4. Peel off the tape and remove the THERMISTOR, PREs.
Figure 4-105. Removing the PRE HEATER (64) and THERMISTOR, PRE
Heat insulator
Tape
Tape
THERMISTOR, PREs
PRE HEATER(64)
PRE HEATER(64)
REAR PAPER
GUIDE
 When installing the THERMISTOR, PRE, make sure to follow
the standard given in the figure below.
 Before pasting the tape, make sure the heaters are correctly
oriented, with the connectors cables coming out on the
Thermistors’ side.
A D J U S T M E N T
R E Q U I R E D
Be sure to refer to Chapter 5 “Adjustment” (see p184) and perform
specified adjustments after replacing or removing this part.
<Adjustment item>
1. Heater Test
40mm 125mm
185mm
THERMISTOR, PREs
REAR PAPER
GUIDE
Hook
(in the middle)