Epson Stylus Pro GS6000 - Page 136

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 136
Confidential
 LEVER SENSOR
Figure 4-104. Removing the LEVER SENSOR
C H E C K
P O I N T
The LEVER SENSOR is secured with hooks. To remove this
sensor, disengage the hooks and disconnect the cable.
 When routing the cable of each sensor, make sure to give it one
turn around the clamps the same as the original routing.
 After installation, make sure to apply thread locker around the
hooks to secure the LEVER SENSOR.
A D J U S T M E N T
R E Q U I R E D
Be sure to refer to Chapter 5 “Adjustment” (see p184) and perform
specified adjustments after replacing or removing this part.
<Adjustment item>
1. Sensor Test
LEVER SENSOR
As seen from the right