EPSON Stylus Pro GS6000 Revision F
PRODUCT DESCRIPTION Control Panel 20
Confidential
1.4 Control Panel
1.4.1 Buttons and Indicators
BUTTONS
Figure 1-7. Buttons
Note *1: When AUTO TAKE-UP REEL is ON in the Menu mode, the roll paper cannot be
fed in the reverse direction.
Button Name Function
a
[Power]
Turns the printer on or off.
b
[Pause/Reset]
Stops printing temporarily, or restarts printing if pressed when the
printer is in the pause mode.
Clears print data in the printer memory if pressed and held for
3 seconds.
The printer returns to the READY state when this button is
pressed in the Menu mode.
c
[Heater]
Selects a heater type. From the right, Pre Heater, Platen Heater,
and After Heater are displayed on the LCD panel. Select a heater
type, and then press the [High Heat] button or [Low Heat] button
to change the preset temperature.
Returns to the previous level when pressed in the Menu mode.
d[Enter]
Sets the selected parameter in the selected item in the Menu mode.
Executes the item if the selected item is for execution only.
e [Paper Feed]
Feeds the roll paper in the forward or reverse direction.
*1
Changes the parameter in the forward or reverse order when
selecting a desired parameter in the Menu mode.
The numeric value is decreased or increased during numerical
input.
f [Menu]
Enters the Menu mode when pressed in the READY state.
Enters the Printer Status menu if pressed during printing.
Stops printing temporarily, or restarts When pressed in the Menu
mode, a desired menu can be selected.
Performs Cleaning (Light) to clean the print heads if pressed and
held for 3 seconds.
g [Low Heat]
Decreases the preset temperature of the heater. You can also
change the preset temperature while printing.
h [High Heat]
Increases the preset temperature of the heater. You can also
change the preset temperature while printing.
To Next Page
Loading...
