Epson Stylus Pro GS6000 - Tests; Skew Test

Epson Stylus Pro GS6000 Revision F
ADJUSTMENT Tests 234
Confidential
5.8 Tests
5.8.1 Skew Test
This checks how much skew the fed paper is, and corrects if the skew amount falls
outside the standard range.
 Paper Used
 Size: 1250 mm
 Type: Marking Film
 Standard value
Within ± 0.5mm
 Procedure
1. Refer to ?5.1.6 Cautions and Preparation for Pattern Printing? (p.197), and
prepare for printing the pattern.
2. Select Adjustment => Skew Check.
3. Confirm that the value is set to 1.0m, and press [Enter]. Then the paper is
ejected and the skew value is measured by the PAPER EDGE SENSOR and is
displayed on the LCD panel.
4. If the value fits within the standard, turn the printer OFF and finish the
adjustment. If not, verify the status of the loaded paper and repeat the check
until the value falls within the standard range.