Epson Stylus Pro GS6000 - Ink Discharge

Epson Stylus Pro GS6000 Revision F
ADJUSTMENT Head Related Adjustments 210
Confidential
5.4.4 Ink Discharge
This allows you to drain ink out of the printer inside mechanism without using cleaning
cartridges.
 Procedure
1. Turn the printer ON.
2. Start the Service Program and select Ink Discharge in the “FLAG CHANGE
& COUNTER RESET” menu.
3. Click [Run], and click the [Finish] button.
4. Turn the printer OFF.
5. Turn the printer back ON to start draining ink. (Remove the cartridges when
requested on the panel.)
6. When you need to replace some parts, carry out the replacement after turning
the printer OFF.
7. Turn the printer back ON. The initial ink charge will be performed. (Place
back the cartridges when requested on the panel)
Figure 5-30. [Ink Discharge] Screen
C A U T I O N
Before performing this, make sure to drain waste ink out of the
drain tank.