Epson Stylus Pro GS6000 - Page 138

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 138
Confidential
4.4.8.2 PLATEN HEATER (64)/THERMISTOR, PLATEN
1. Remove the Platen (Step 1 to 3 in 4.4.5.2 VACUUM FAN). (p103)
2. Peel off the heat insulator.
3. Peel off the tape and the PLATEN HEATER(64)s and remove them.
4. Remove the screw and remove the THERMISTOR, PLATENs.
A) Silver, Phillips, Pan with S.W & P.W M3x5: two pieces
Figure 4-106. Removing the PLATEN HEATER (64) and THERMISTOR, PLATEN
When reassembling the Platen, take care not to catch the cables
between the Platen and the fixing plates. See Figure 4-47.
C A U T I O N
In the next step, do not touch any screws adjusting the platen
(marked with yellow circles in the figure below), or the printer may
not print normally. The screws keep the factory-adjusted
Parallelism.
Inside the Platen
VACUUM FAN
Heat insulator
Platen
A
PLATEN HEATER(64)
THERMISTOR, PLATEN
Tape
Tape