Epson Stylus Pro GS6000 - Page 139

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 139
Confidential
 When installing the THERMISTOR, PLATEN, make sure to
follow the standard given in the figure below.
 When attaching the heaters, make sure to align them right on
the ribs so as not to let them sticking out of the ribs.
 Before pasting the tape, make sure the heaters are correctly
oriented, with the plugs on the rear side.
A D J U S T M E N T
R E Q U I R E D
Be sure to refer to Chapter 5 “Adjustment” (see p184) and perform
specified adjustments after replacing or removing this part.
<Adjustment item>
1. Heater Test
483mm
425mm
52mm
THERMISTOR, PLATEN
Platen