Epson Stylus Pro GS6000 - Page 140

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 140
Confidential
4.4.8.3 AFTER HEATER (64)/THERMISTOR, AFTER
1. Remove the MAINTENANCE COVER ASSY (both). (p91)
2. Remove the MAINTE COVER, B (both). (p92)
3. Remove the PAPER GUIDE COVER (both). (p94)
4. Open the FRONT CLEAR COVER.
5. Remove the After Heater Cover. (p97)
A) Silver, Phillips, Pan with S.W & P.W M4x8: five pieces
B) Silver, Phillips, Bind machine screw M3x6: five pieces
6. Peel off the heat insulator.
7. Peel off the AFTER HEATER (64)s and remove it.
8. Remove the two screws and remove the THERMISTOR, AFTERs.
A) Silver, Phillips, Pan with S.W & P.W M3x5: two pieces
Figure 4-107. Removing the AFTER HEATER (64) and THERMISTOR, AFTER
Heat insulator
AFTER HEATER(64)
After Heater Cover
THERMISTOR, AFTER
Tape
Tape
A