Epson Stylus Pro GS6000 - Page 141

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 141
Confidential
 When installing the THERMISTOR, AFTER, make sure to
follow the standard given in the figure below.
 Before pasting the tape, make sure the heaters are correctly
oriented, with the connectors cables coming out on the
Thermistors’ side.
A D J U S T M E N T
R E Q U I R E D
Be sure to refer to Chapter 5 “Adjustment” (see p184) and perform
specified adjustments after replacing or removing this part.
<Adjustment item>
1. Heater Test
THERMISTOR, AFTER
35mm