Epson Stylus Pro GS6000 - Optional Accessories and Maintenance Kit

Epson Stylus Pro GS6000 Revision F
TROUBLE SHOOTING Remedies for Error Messages 52
Confidential
NO CARTRIDGE
INSTALL INK CARTRIDGE
No ink cartridge is installed. Install an ink cartridge correctly.
The ink cartridge cannot be detected correctly. Replace the ink cartridge. When the error still occurs after the
replacement, check the connection status from the cartridge holder to the
main board.
INK CARTRIDGE ERROR
REPLACE CARTRIDGE
The ink cartridge was found faulty. There may be some bad contact or
dew condensation in the cartridge.
Remove the ink cartridge and reinstall it. When the error still occurs after
the reinstallation, replace the cartridge with a new one (do not reinstall the
defective ink cartridge at this time). To prevent condensation from
forming in the new ink cartridge, leave the cartridge at room temperature
for more than four hours before installing it.
INK CARTRIDGE
PLEASE USE GENUINE EPSON INK
CARTRIDGES
Non-genuine ink cartridge is installed. Replace the ink cartridge with a genuine Epson ink cartridge. Using a
non-genuine ink cartridge may void Epson's warranty.
INK CARTRIDGE
NON-GENUINE CARTRIDGE MAY
NOT PERFORM AT OPTIMUM
CONTINUE?
<YES NO>
INK CARTRIDGE
THIS MAY VOID EPSON'S
WARRANTY.
DO YOU ACCEPT THIS?
<ACCEPT DECLINE>
INK CARTRIDGE
REPLACE INK CARTRIDGE
The ink cartridge is expended. Replace the ink cartridge with a new one.
COMMAND ERROR
CHECK DRIVER SETTINGS
The printer received damaged or collapsed print data. Cancel the print job, and try another one.
The printer received print data with a wrong command.
The installed printer driver is not correct for the printer. Install the correct printer driver.
PAPER SKEW
LOAD PAPER PROPERLY
The paper loaded on the printer is skewed. Correct the paper skew. If the print job is proceeded with the paper
skewed, some portion of the image will extend out of the printable area.
If an error has occurred when using Auto Take-Up Reel Unit, the roll
paper may not be rolled up straight. This phenomenon can be avoided by
trimming both of the front edges when setting the roll paper to the
scroller.
PAPER ERROR
LOAD PAPER PROPERLY
REFER TO THE MANUAL
The paper is not loaded correctly. Release the paper lever (PRESSURE LEVER), and set the paper
correctly.
Message on LCD Description Remedy/Point to be checked