Epson Stylus Pro GS6000 - Page 133

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 133
Confidential
4.4.7.8 Others
 F COVER SENSOR (L)
1. Remove the TOP COVER. (p85)
2. Remove the PANEL COVER, T. (p86)
3. Remove the SIDE COVER. (p89)
4. Remove the IH COVER (left only). (p90)
5. Remove the REAR PAPER GUIDE.(p96)
6. Remove the SPINDLE GUIDE COVER.(p97)
7. Disconnect the connector of the F COVER SENSOR (L) from the SUB_C
BOARD ASSY. (p121)
8. Release the cable from the clamps.
9. Remove the two screws, and remove the F COVER SENSOR (L).
A) Silver, Phillips, Pan with S.W & P.W M2x12: two pieces
Figure 4-98. Removing the F COVER SENSOR (L)
 F COVER SENSOR (R)
A) Silver, Phillips, Pan with S.W & P.W M2x12: two pieces
Figure 4-99. Removing the F COVER SENSOR (R)
C H E C K
P O I N T
 Basically you can remove any of the sensors in this section in
the same way. Therefore, the detailed procedure is given only
for the F COVER SENSOR (L).
 So as to restore the original routing of each sensor cable, it is
recommended to record the routing in some way before
disconnecting the cables.
A
F COVER SENSOR (L)
As seen from the front left
Do not invert L and R parts as the front cover would be very heavy
to lift and would drop without restraints, causing eventual injury
due to the weight of the cover.
A D J U S T M E N T
R E Q U I R E D
Be sure to refer to Chapter 5 “Adjustment” (see p184) and perform
specified adjustments after replacing or removing this part.
<Adjustment item>
1. Sensor Test
A
F COVER SENSOR (R)
As seen from the front right