Epson Stylus Pro GS6000 - Page 160

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 160
Confidential
13. Remove the three screws at the bottom of the Head Base.
A) Silver, Hexagon socket M3x8: three pieces
14. Remove the screw from the front side and remove the spring from inside. (right
head only)
B) Silver, Hexagon socket M3x12: one piece
15. Lift the PRINT HEAD gently while pushing the square part at the front bottom,
and remove the PRINT HEAD with the Head Base.
Figure 4-133. Removing the PRINT HEAD with the Head Base
16. Place the PRINT HEAD on the jig aligning the head with the hole of the jig (Head
Holder) as shown below.
17. Disengage the hooks on both sides, and remove the HEAD COVER.
18. Remove the two screws on both sides, and remove the PRINT HEAD (with the
VALVE ASSEMBLY, HEADs contained inside) from the Head Base.
A) Silver, Hexagon socket M3x8: two pieces
Figure 4-134. Removing the PRINT HEAD (with the VALVE ASSEMBLY, HEADs)
C A U T I O N
In the next step, take care not to remove the wrong screws. Those
screwed outside differ from those screwed inside in size and length.
Push here when lifting
PRINT HEAD
B
A
Spring (right only)
As seen from the top
Screw (right only)
Hook
A
VALVE ASSEMBLY, HEADs
HEAD COVER
Head Base
Head Holder
Hook