Epson Stylus Pro GS6000 - Page 190

Epson Stylus Pro GS6000 Revision F
ADJUSTMENT Overview 190
Confidential
Head Related Adjustments Head Rank Input Allows inputting the head L (1) and head R (2) Rank ID code.
√√ p.207
Nozzle Check Pattern Print a pattern allowing confirming all head nozzles are correctly firing ink.
√√ p.208
Cleaning and Washing Allow Cleaning the head or removing the ink form the ink system.
√ p.209
Initial Ink Charge Flag Allow forcing the printer to flow the ink through the ink system.
√√ p.211
Head Slant and Alignment Adjustment Print a pattern allowing to confirm the head slant position + adjust the head angle
if needed.
√√√p.212
Head Nozzles Alignment Adjustment Print a pattern allowing to confirm the heads alignment + adjust the head
alignment & angle if needed.
√√ p.218
Head Uni-D/Bi-D Low Gap Adjustment Allow to check and adjust the firing timing of each nozzle line.
√ p.219
Head Counter Reset Modify the NVRAM so that the head counter is reset to Zero.
√ p.233
PF Related Adjustments PF Reduction Belt Tension Adjustment Mechanical adjustment allowing to adjust the PF motor Reduction belt tension to
a specified level.
√ p.222
Paper Feed Adjustment Confirm the distance between two horizontal lines + input the actual value.
√ p.223
PF Counter Reset Modify the NVRAM so that the Paper Feed counter is reset to Zero.
√ p.233
Other Adjustments RTC and USB ID Overwrite the Clock Date, Serial Number and/or USB ID registered on the
printer.
√√ p.224
Firmware Update (Main, Heater, Network, EDM) Allow checking the firmwares versions currently installed and upgrade them if
necessary.
√ p.225
Pump Counter Reset Modify the NVRAM so that the Pump Motor counter is reset to Zero.
√ p.233
Washing Sequence Flag Allow modifying the flags to define what the printer’s behavior should be at the
next power-on.
√ p.227
Class Items Overview
What to Use
Page
SP SM Mech