Epson Stylus Pro GS6000 - Page 214

START
Select Adjustment => Head Slant => CR Head Slant
=> Adjust => [Enter] Print and press the [Enter] button
to print the adjustment pattern or select
"Head Slant & Alignment Adjustment"
in the ADJUSTMENT INDIVIDUAL Menu of the
Service Program.
NGNG
NG
NG
NG
OKOK
OK
OK
OK
See 5.1.6 to prepare for printing the adjustment pattern.
Check the head angle in sub
scanning direction.
(See SUB SCANNING DIRECTION)
Check the head angle in sub
scanning direction.
(See SUB SCANNING DIRECTION)
Procedure when only HEAD R (2) is replaced
Print Confirmation pattern and
check that no abnormality exists.
Check the alignment.
Check the alignment.
Check the HEAD R
(2) angle.
Loosen the head base screws C,
turn the adjustment screw E to
adjust the heads alignment, then
fasten the head base screws C.
Loosen the right head fixing
screws B, turn the adjustment
screw F to adjust the head R slant
then fasten the fixing screws B.
Print the adjustment pattern using
the operation panel or the Service
Program.
Check the angle of
HEAD R (2).
Loosen the right head fixing
screws B, turn the adjustment
screw F to adjust the head R slant
then fasten the fixing screws B.
Print Confirmation pattern and
check that no abnormality exists.
Print the adjustment pattern using
the operation panel or the Service
Program.
Check the angle of
HEAD R (2).
CHECK
POINT
See the page 209 for further illustrations of
the screws and the patterns.