Epson Stylus Pro GS6000 - Page 29

Epson Stylus Pro GS6000 Revision F
PRODUCT DESCRIPTION Control Panel 29
Confidential
 Details of PAPER SETUP
After you have selected the paper number, make the following settings.
Item Parameter Explanation
PRINT MODE
MAX QUALITY You can select the print quality (print mode) according to the usage of print data or print speed.
 MAX QUALITY, QUALITY1, QUALITY2:
Performs high-quality printing. Use this mode when printing high quality graphic data that includes photo
data. MAX QUALITY provides priority to print quality. QUALITY1 is balanced between quality and
efficiency. QUALITY2 provides priority to print efficiency.
 QUALITY3:
Performs standard printing. Use this mode when printing graphic data.
 SPEED1, SPEED2, SPEED3:
Performs high-speed printing. Use this mode when printing text or graphics. SPEED1 provides priority to
print quality. SPEED2 is balanced between quality and efficiency. SPEED3 provides priority to print
efficiency.
QUALITY1
QUALITY2
QUALITY3
SPEED1
SPEED2
SPEED3
PAPER FEED ADJUST
LINE FEED ADJUST
You can set the paper feed amount of the printable area. If the paper feed value is too large, white horizontal
micro-banding may appear. If the paper feed value is too small, dark horizontal micro-banding may appear.
PRINT SAMPLE PATTERN
HEAD ALIGNMENT BI-D ALL You can perform print head alignment. Check the pattern and enter the value that has the smallest gaps.
PRE HEATER
OFF You can set the Pre Heater temperature. The Pre Heater is located under the rear paper guide. Set up to preheat
the paper before printing and insulate the temperature change in the printer section.
a. Print head, b. Pre Heater, c. Roll paper
For appropriate temperatures to set to this function, see the instructions included with the paper, or
contact your supplier.
30
o
C to 50
o
C (86
o
F to 122
o
F)
a
b
c
C H E C K
P O I N T