Epson Stylus Pro GS6000 - Page 31

Epson Stylus Pro GS6000 Revision F
PRODUCT DESCRIPTION Control Panel 31
Confidential
M/W ADJUSTMENT
(Micro Weave Adjustment)
LOW A to B You can improve the print quality by adjusting the print mode you have set.
 LOW A, B:
The effect of M/W Adjustment function will be minimized. If obvious white lines or uneven print density
appear on printed paper in LOW A, set to LOW B.
 MEDIUM A, B, C, D:
The printing joint between two head passes will have a wave form. If obvious white lines or uneven print
density appear on printed paper in MEDIUM A, print samples using the other settings and select the best print
result from MEDIUM B to MEDIUM D.
 HIGH A, B, C, D:
Perform printing at a slow speed compared with “MEDIUM”. Set up this menu when improving the print
quality compared with “MEDIUM”. If obvious white lines or uneven print density appear on printed paper in
HIGH A, change the setting to the one with the best print result in HIGH B to HIGH D.
 EXTRA HIGH A:
Performs “MEDIUM” printing using half of the nozzles of the print head. Since only a half of the nozzles is
used, printing speed becomes half of MEDIUM A to MEDIUM D. Set up this menu when improving the print
quality compared with HIGH A to HIGH D.
 EXTRA HIGH B:
Performs “MEDIUM” printing using the other half of the nozzles of the print head that is used for EXTRA
HIGH A. Since only a half of the nozzles is used, printing speed becomes half of MEDIUM A to MEDIUM D.
Set up this menu when improving the print quality compared with HIGH A to HIGH D.
MEDIUM A to D
HIGH A to D
EXTRA HIGH A to B
PAPER SUCTION
HIGH
You can set the suction pressure used to feed the printed paper.
LOW
DRYING TIME 0.0sec to 10.0sec
You can set the ink drying time for each print head pass. The range is 0 to 10 seconds. Depending on the ink
density, paper type or printing speed, the ink does not dry soon. In this case, set the drying time longer.
When you set the drying time longer, missing dots might occur in the printing.
CARRIAGE MOVEMENT
DATA WIDTH You can set the range that the print head moves while printing.
 DATA WIDTH:
The print head moves between the print data width. This improves the print speed since decreasing the
transferring range of the print head.
 PRINTER FULL WIDTH:
The print head moves from origin to the maximum paper width. This keeps printing quality the same even though
the printing size (width) differs.
PRINTER FULL WIDTH
PRINT MULTIPLE LAYER
OFF
You can set the overwrite count per line.
2 to 8
Item Parameter Explanation
C A U T I O N