Epson TM-T90 - Page 136

Confidential
EPSON
TITLE SHEET
REVISION
NO.
SHEET NEXT
F
119 118
TM-T90
Specification
(STANDARD)
•
Adjustment of black-color density:
The black-color density is affected only in two-color printing.
This is not affected for single-color printing.
•
The adjustment function of black-color density is enabled only in the ANK/Multilingual model.
It is disabled in the Japanese model.
[Notes] • This function code fn
= 5 is enabled only in the user setting mode.
• The values changed with this command become effective with the following:
•
Execution of <Function 2> of this command (recommended)
•
Turning the power on again
•
Hardware reset by the reset signal input through the interface
• The density of printing with four-part energizing on the two-color paper may not be changed.
• To improve the quality of two-color printing, it is recommended to print with two-part
energizing.