Epson TM-T90 Specification

Confidential
EPSON
TITLE SHEET
REVISION
NO.
SHEET NEXT
F
61 60
TM-T90
Specification
(STANDARD)
3.4 Panel LEDs
1) Power (POWER) LED: Green
On: Power is stable.
Off: Power is not stable.
Flashing: During execution of each operation.
<Flashing pattern>
Power on (during each execution): Flashing
Approximately 320 ms
Power off termination (after executing
DLE DC4 2
): Flashing
2) Paper roll end (PAPER OUT) LED: Red
On: The roll paper near end or real end is detected.
Off: Paper is loaded (normal condition).
Flashing: • Self-test waiting state for test print.
• Macro execution standby state when the macro execution command is used.
Table 3.4.1 Standby State Indication
State PAPER LED flashing pattern Recovery conditions
Waiting for self-test printing
to be continued or macro
execution ready state.
PAPER OUT
Approximately 320 ms
Pressing the FEED button
causes self-test printing to be
continued or executes the
macro.
NOTE: A macro can be executed r times (r specifies the number of times to execute the macro)
within the specified definition range. The macro can be executed continuously or can be
executed by pressing the button. If the macro is executed by pressing the FEED button, the
PAPER OUT LED flashes to indicate the macro execution ready state. (See Section 6,
Commands.)

Epson TM-T90 Specifications

General

Brand	Epson
Model	TM-T90
Category	Printer
Language	English