Epson TM-T90 Specification

Confidential
EPSON
TITLE SHEET
REVISION
NO.
SHEET NEXT
F
65 64
TM-T90
Specification
(STANDARD)
3.7 Memory Switch Setting Mode
1) Memory switch setting functions
The following memory switches can be set by operating the button and opening and closing the cover.
➀ Enabling or disabling the autocutter
➁ Print density
➂ Setting communication conditions of the serial interface
➃ Making settings related to serial communication
•
Capacity of the receive buffer
•
Data processing for receiving errors
•
Conditions for BUSY
➄ Selection of interface reset signal
➅ Setting paper width
➆ Type of paper (single-color/two-color)
➇ TM-T88II-compatible mode and the power on information status (except for Japanese model)
2) Starting the memory switch setting mode
Open the cover and turn the power on while holding down the paper FEED button (located inside the
printer), and continue holding down the paper FEED button until the ERROR LED light is on; release
the paper FEED button when the ERROR LED light is on. Next, press the paper FEED button twice,
and close the cover. Then, the printer prints the possible setting contents of the memory switch and
instructions. Follow the instructions to set the memory switches.
3) Ending the memory switch setting mode
Once the setting is performed, the contents of the settings are stored; then the printer executes the
initialization. After initializing, the printer enters the normal state.
Paper FEED button
(inside the printer)

Epson TM-T90 Specifications

General

Brand	Epson
Model	TM-T90
Category	Printer
Language	English