Confidential
EPSON
TITLE
SHEET
REVISION
NO.
SHEET
NEXT
F
TM-T90
Specification
(STANDARD)
6 5
4) Product specifications and supported characters
Table 1.2.3 Product Specifications and Supported Characters
Product Specifications Supported Characters
ANK model ---
Multilingual model
(simplified Chinese)
Simplified Chinese characters
Multilingual model
(traditional Chinese)
Traditional Chinese characters
Multilingual model
(Thai)
Thai characters
Multilingual model
(Korean)
Korean characters
Japanese model
•
Alphanumeric
•
Extended graphics
•
International characters
Japanese characters, special
font
(ANK = alphanumeric)
1.3 Autocutter
1) Cutting method: Scissors type with separated blades
2) Cutting type: Partial cut (cutting with one point in left edge left uncut)
(default setting)
Full cut (completely cut) is also possible as a dealer option.
(Set by changing the position of the autocutter unit.)
NOTES: • After cutting, paper must be fed approximately 1 mm or more, then stopped. This
length corresponds to 7 dots or more for the ANK or Multilingual model, and 8 dots or
more for the Japanese model, because, if it is not done, paper may jam in the autocutter
unit.
• To prevent dot displacement after cutting, it is recommended to feed paper for
approximately 1 mm or more before printing.
• Changing partial cut or full cut is not controlled by a software command.
• Full cut by an autocutter can be used only when the printer is installed vertically or
hanging on the wall, since if the printer is installed horizontally and the autocutter full cut
is used, a cut sheet may drop in the paper path, and it may cause a double-cut, paper
jam, or autocutter error.
• The cutting type (partial cut or full cut) must be selected before the printer is first used.
If the cutting type is changed from partial cut to full cut after the printer has been used,
the printer may not be reliable because the wear-out level of the cutter blade differs.
To Next Page
Loading...
Need help?
General
