Epson TM-T90 - Appendix G: Notes on Turning the Printers Power off; Appendix H: Comparison Table of Tm-T90 and Tm-T88 Ii

Confidential
15
SHEET
App. 15
NO.
SHEET
REVISION
F
TITLE
NEXT
App. 16
TM-T90
Specification
(STANDARD)
APPENDIX H: COMPARISON TABLE OF TM-T90 AND TM-T88II
H.1 Comparison of Specifications (1)
TM-T90 (except Japanese model) TM-T88II
1. Dot density 0.141 mm/dot 0.141 mm/dot
2. Paper width 80 mm {3.15"}
60 mm {2.36"}
(using an optional paper roll spacer)
58 mm {2.28"}
(using an optional paper roll spacer)
80 mm {3.15"}
3. Print speed Normal printing: 170 mm/s {6.69"/s}
maximum
Ladder bar code or Two-dimensional
code printing: 100 mm/s {3.94"/s}
maximum
Four-part energizing mode: 70 mm/s
{2.76"/s} maximum
Two-color printing: 100 mm/s {3.94"/s}
maximum
120 mm/s {4.72"/s} maximum
Ladder bar code: Approximately
42 mm {1.65"/s}
Low power consumption: 70
mm/s {2.76"/s} maximum
4. Font C None (See Note) Not available
5. NV bit image buffer 0 through 384KB 256KB
6. NV user memory 1KB through 192KB 1KB
NOTE: Font C (8 × 16) is supported in Japanese model.
H.2 Comparison of Specifications (2)
TM-T90
(Japanese model)
TM-T88II
(Japanese model)
1. Dot density 0.141 mm/dot 0.141 mm/dot
2. Paper width 58 mm {2.28"}
60 mm {2.36"}
(with an attached paper roll spacer)
80 mm {3.15"}
(without an attached paper roll spacer)
58 mm {2.28"}
80 mm {3.15"}
3. Print speed Normal printing: 170 mm/s {6.69"/s}
maximum
Two-color printing: 90 mm/s {3.54"/s}
120 mm/s {4.72"/s} maximum
4. Font C
8 × 16 dots
None