TM-T90
Specification
(STANDARD)
H.3 Comparison of Commands
Command TM-T90 original
TM-T88II-compatible
mode
(Msw 8-7 On)
TM-T88II
DLE EOT
1. Add the following bits to the printer
status (when n = 1)
Bit 5: Not waiting for online
recovery/ waiting for online
recovery
Bit 6: PAPER FEED button not
being pressed/ PAPER
FEED button being pressed
2. Add the following bits to the error
cause status (when n = 3)
Bit 2: Mechanical error has not
occurred/ occurred
In the TM-T88II
compatible mode, the
second bit is always 0,
because a cover open
error during printing is
an automatic recovery
error.
1. Printer status (when n = 1)
Bit 5: Undefined
Bit 6: Undefined
2. Error cause status (when n
= 3)
Bit 2: Undefined
DLE ENQ
n = 0: Cancellation of waiting for
online recovery status is
added
←
DLE DC4 (2)
Newly added
←
--
ESC &
User-defined characters and
user-defined bit-images can be
defined simultaneously (the size is
the same as before).
When the command is executed, the
definition of a user-defined bit-image
is not cleared.
→
User-defined characters and
user-defined bit-images
cannot be defined
simultaneously. When the
command is executed, the
definition of any user-defined
bit-image is cleared.
ESC =
Range: 1 ≤ n ≤ 3
→
Range: 0 ≤ n ≤ 255
ESC @
Executes reading a default value by
customizing the printer.
←
ESC R
[Default]
Except for Korean model: n=0
For Korean model: n=13
→
[Default] n=0
ESC V
Add the range, n = 2, 50. (operation
is the same as when n = 1, 49)
Range: 0 ≤ n ≤ 2, 48 ≤ n ≤ 50
←
Range: 0 ≤ n ≤1, 48 ≤ n ≤ 49
To Next Page
Loading...
