Epson TM-U375 - Attachment; Intermediate Drive Roller Assembly and Guide Frame Assembly B Attachment

5-26
Main Assembly 3 Intermediate Drive Roller Assembly and Guide Frame Assembly B
Attachment
Assembly
Step
Part Name Assembly Procedure
1
2
3
★
Intermediate drive shaft spring
Intermediate drive roller ass'y
Guide frame assembly B
Sub-assembly E
CCS-tite (M2.5 x 4) x 1
CCS-tite (M2.5 x 8) x 1
CCS-tite (M2.5 x 5) x 2
• Insert the Intermediate drive shaft spring in portion A of the Platen
holder unit.
• Pass the Intermediate drive roller assembly from the right side of the
Main frame assembly through the hole, to the Intermediate drive
shaft spring, and then align groove B with hole C.
• Insert the Guide plate between portions D (➡ 1 direction); then move
the Guide frame assembly B in the ➡ 2 direction to secure it in place.
Fasten the guide frame with the screws.
<Checkpoints>
• Make sure that the tab of the Guide frame assembly B is aligned with
the indent of the Main frame assembly.
• Make sure not to confuse the screws.
• Verify that portion F of the main frame contacts portion E of the Guide
plate.
CONFIDENTIAL