5-40
5.3.4 Adjustments
When servicing or repairing the printer and after replacing any parts, be sure to perform the following adjustments to assure
correct operation.
Adjust-
ment
Step
Adjustment A Gear-Intermediate and Gear-Paper Feed Motor Backlash
1
2
3
Loosen the fastening screws of the Motor-
Paper feed.
Move the Motor-Paper feed to adjust the
backlash.
Tighten the fastening screw of the Motor-
Paper feed.
• Nominal value (A): 0.05 to 0.15 mm (0.002 to 0.006")
Procedure
Adjustment Notes
CONFIDENTIAL
To Next Page
Loading...
