5-44
5.4.2 Sub-assembly
Sub-assembly A N.E. Detector Unit Assembly
Assem-
bly Step
1
2
3
4
★
5
Part Name Assembly Procedure
Holder-N.E. detector
Nut
Microswitch
CBB-tite (M2 x 8) x 1
Lever-N.E. detector
N. E. detector cable assembly
• Attach the Nut to the Holder-N.E. detector by inserting its curved face
first.
• Attach the Microswitch to the Holder-N.E. detector and tighten the
screw.
• Place protrusions B of the Lever-N.E. detector onto section A of the
Holder-N.E. detector.
• Align the U-shaped grooves with dowels C by turning the Lever-N.E.
detector in the direction of the arrow, with protrusions B as the center.
<Checkpoints>
• Verify that the Nut is mounted on the correct place in the correct
direction.
• Make sure that the Microswitch is attached in the proper direction.
• Connect the N. E. detector cable assembly to the Microswitch.
• Route the wires as shown in the figure below.
CONFIDENTIAL
To Next Page
Loading...
