Epson TM-U375 - Plate-Base Assembly and Plate-Auxiliary Attachment

5-51
Assembly
Step
Assembly ProcedurePart Name
Main Assembly 3 Plate-Base Assembly and Plate-Auxiliary Attachment
1
2
3
★
• Attach the N.E. detector unit connector to CN5 on the Main circuit
board unit.
• Insert the cables connected to the Main circuit board unit into hole
A of the Case-Main.
• Place tabs B of the Plate-Base assembly under portions C of the
Case-Main; then turn the plate in the ➡ direction. Make sure that holes
D are aligned with dowels E; then tighten the screws.
• Align dowels F of the Plate-Auxiliary with pole G of the Case-Main;
then secure the plate with the screw.
<Checkpoint>
• Verify that the cables are not caught between the Case-Main and the
Plate-Base assembly.
(N.E. detector unit)
Plate-Base assembly
CPT-B (M3 x 10) x 2
Plate-Auxiliary
CPP-tite (M3 x 10) x 1
CONFIDENTIAL