Epson TM-U375 - GND Plate Attachment

5-56
Assembly
Step
Assembly ProcedurePart Name
Main Assembly 8 GND Plate Attachment
(1)
2
3
★
(Cable)
Eye lock
GND plate
CCS-tite (M3 x 6) x 2
• Connect the cable of the Switch circuit board assembly to the
connector on the Main circuit board unit.
• Bundle all the cables in front of the Main circuit board unit with the
Eye lock. Twist the Eye lock as indicated by the ➡ so that it does not
come off.
• Insert tab A on the GND plate into hole B in the Case-Main. Tighten
the screw in hole C; then tighten the screw in hole B.
<Checkpoint>
• Make sure that the GND plate is secured by tightening the screws in
the proper order (hole C, then hole B).
CONFIDENTIAL