1-5
● Validation paper
[Units: mm]
Figure 1-8. Validation Paper Print Area
● Slip paper (Paper width: 85 to 182 mm (3.35" to 7.2"))
[Units: mm]
Figure 1-9. Slip Paper Print Area
(Paper width: 85 to 182 mm (3.35" to 7.2"))
Note
All the numeric values are typical. Take the margin into consideration when setting printing position in paper feeding
direction.
● Slip paper (Paper width
W: 70 to 85 mm (2.76" to 3.35"))
Printable area X = W – 22 mm
[Units: mm]
Figure 1-10. Slip Paper Print Area
(Paper width: 70 to 85 mm (2.76" to 3.35"))
(✽1) Paper feeding after manual cutting is not included.
(✽2) If slip paper with curls at the paper end is used, character misalignment may occur within the area
about 17 mm (.67") from the paper edge.
CONFIDENTIAL
To Next Page
Loading...
