3-3
(5) When using the take-up spool, follow steps 1), 2) and
3) below.
1) Pull out the side of the take-up spool and insert the
tip of the paper roll into the groove on the spool as
shown in Figure 3-6.
2) Rotate the spool two or three times to secure the
paper and reinsert the side of the take-up spool.
3) Install the take-up spool in the printer.
Figure 3-6. Inserting the Paper into the Spool
(6) Tear off the paper roll (receipt paper) on the cutter; then
close the printer cover.
Note
When the printer cover is open, the PAPER FEED button is
inactive.
Figure 3-4. Loading Paper Roll
(4) Insert the tip of the paper into the paper inlet as far as
it will go, and push the PAPER LOAD switch to feed the
paper roll until the paper comes out from the top of the
printer.
Note that the ➡ in the exploded drawing below points
towards the front of the printer.
Figure 3-5. Inserting Paper into the Paper Inlet
CONFIDENTIAL
To Next Page
Loading...
