7800/7700 MultiFrame Manual
7814 Series Dual HDTV Up/Down/Cross Converters
Revision 1.1.3 Page - 129
7.28.2. Reference Monitor
7.28.2.1. Reference Status Monitor
The Reference Status Monitor is used to see what the current valid reference standard is being applied to
the module. When no reference is detected, the Reference Status window will state None.
7.28.2.2. Reference Type
The Reference Type monitor is used to inform the user whether the incoming genlock signal is of bi-level
sync or tri-level sync
7.28.2.3. Genlock Standard
External Genlock Standard reports if a valid video reference has been supplied to the selected reference
input and indicates the standard that is detected when a valid reference is applied.
7.28.3. Reference Traps
To enable a specific Fault trap, click the small box beside the relevant fault and ensure that a check mark
appears in the box. To disable a specific Fault trap, click the small box beside the relevant fault and
ensure that a check mark does not appear in the box.
To Next Page
Loading...
