7800/7700 MultiFrame Manual
7814 Series Dual HDTV Up/Down/Cross Converters
Revision 1.1.3 Page - 27
6. HIGH LEVEL CARD CONTROLS
To access high-level card controls, select the card from the navigation tree that you wish to configure (i.e.
7814UDX-AES8-3G-2) and right click using your mouse and select “View Configuration”. The following six
control tabs will appear.
Figure 6-1: High Level Card Controls
6.1. GENERAL CONTROL TAB
The VLPRO interface for configuring the GENERAL control tab appears as follows:
Figure 6-2: Misc Faults Tab
To enable a specific Fault trap, click the small box beside the relevant fault and ensure that a check mark
appears in the box. To disable a specific Fault trap, click the small box beside the relevant fault and
ensure that a check mark does not appear in the box.
To Next Page
Loading...
