7800/7700 MultiFrame Manual
7814 Series Dual HDTV Up/Down/Cross Converters
Revision 1.1.3 Page - 7
1.2. PRODUCT OPTIONS
This manual covers all variations and ordering options for the 7814 series platform. The majority of card
controls are common across all products variations (7814UDX, 7814UC, 7814XC, 7814HDC) and
ordering options. A small number of items change depending on the product variation and ordering option.
The following chart provides a list of available product variations/ordering options and outlines what
module control changes based on each.
"DMX Loss of Video Mode" control is available only with –AES8 versions
● AUDIO INPUT control tab
AUDIO INPUT control tab is available only with –AES8 versions
● AUDIO PROC CH1-CH4/CH 5-CH8/CH9-CH12/CH13-16 control tabs
All selectable options under “Source X” and “Source Y” controls within AUDIO PROC CH1-
CH4 control tab are labeled slightly differently than non-AES versions. In –AES8 versions,
selectable options are labeled as Channel 1…N rather than DMX Channel 1…N
done to reflect that –AES8 versions of 7814 modules include an up-
that chooses whether to process de-embedded audio or AES audio for a particular channel
pair.
● AUDIO 5.1 DOWN MIX control tab
All selectable options in the “L Source", "R Source", "C Source", "LFE Source", "Ls
Source", "Rs Source" controls within the AUDIO 5.1 DOWN MIX control tab are labeled
slightly differently than non AES versions. In the –AES
8 versions, selectable options are
labeled as Channel 1….N rather than DMX Channel 1….N. This does not to reflect that the
–AES8 versions of the modules include an up-front audio selector that chooses whether to
process de-embedded audio or AES audio for a particular channel pair.
● AUDIO/VIDEO TRAPS control tab
Traps for "AES 1" through "AES 8" audio inputs
Under the “Video Input Source”
control, the option to select the Main PGM source and
Fiber PGM source.
● AUDIO PROC CH1-4/CH5-8/CH9-12/CH13-16 control tabs
Within the “Source X” and “Source Y” controls selection of Up Mix L Front, Up Mix R Front,
Up Mix Centre, Up Mix LFE, Up Mix L Surround, Up Mix R Surround, Up Mix Delayed L In,
Up Mix Delayed R In is supported only when the +UMX is present.
● UP MIX CONTROL tab
The UP MIX control tab is only present with the +UMX option
● INTELLIGAIN CONFIGURATION control tab
The IntelliGain™ control tab displays the top-level IntelliGain™
are a number of parameters that control both the Intelligent leveler and the on-board
dynamic processor (compander, expander, limiter)
To Next Page
Loading...
