evertz MultiFrame 7814 Series - Deinterlacer Status

7800/7700 MultiFrame Manual
7814 Series Dual HDTV Up/Down/Cross Converters
Page - 54 Revision 1.1.3
7.6.1.3. List of Cadences
Cadence 3:2
When enabled, the video de-interlacer will search for and lock onto embedded
3:2 sequences and perform inverse 3:2 pull-down to de-
interlace the input
signal.
Cadence 2:2
When enabled, the video de-interlacer will search for and lock onto embedded
2:2 sequences and perform inverse 2:2 pull-down to de-
interlace the input
signal.
Cadence 2:2:2:4
When enabled, the video de-interlacer will search for and lock onto embedded
2:2:2:4 sequences and perform inverse 2:2:2:4 pull-down to de-
interlace the
input signal.
Cadence 2:3:3:2
When enabled, the video de-interlacer will search for and lock onto embedded
2:3:3:2 sequences and perform inverse 2:3:3:2 pull-down to de-
interlace the
input signal.
Cadence 3:2:3:2:2
When enabled, the video de-interlacer will search for and lock onto embedded
3:2:3:2:2 sequences and perform inverse 3:2:3:2:2 pull-down to de-interlace the
input signal.
Cadence 5:5
When enabled, the video de-interlacer will search for and lock onto embedded
5:5 sequences and perform inverse 5:5 pull-down to de-
interlace the input
signal.
Cadence 6:4
When enabled, the video de-interlacer will search for and lock onto embedded
6:4 sequences and perform inverse 6:4 pull-down to de-
interlace the input
signal.
Cadence 8:7
When enabled, the video de-interlacer will search for and lock onto embedded
8:7 sequences and perform inverse 8:7 pull-down to de-
interlace the input
signal.
7.6.2. Deinterlacer Status
7.6.2.1. Deinterlacer Operating Mode
The De-Interlacer Operating Mode is used to notify the current operating mode of the De-interlacer. This
will inform if the de-interlacer is operating in Motion-Adaptive DIR-VT or Bypassed.